简体中文   English
广东耀发智能设备有限公司
Hotline13380271688
Location:Home >> Products >>  Edging

Double side edging machine (simultaneous edging on both sides)

Equipment usage/function description: mainly used to grind the edges of PCB sheets to make them smooth; 1.1. This equipment can also be used as a placement plate; Edge grinding; Plate collecting combination line, 1.2 Plate collecting machine and plate releasing machine can be purchased as required; 1.3 The plate collector and plate dispenser are independent operation panels; 1.4 Primary process

Product introduction Layout Video introduction Equipment case
    1. Equipment Usage/Function Description:

    It is mainly used to grind the edge of PCB to make it smooth;

    1.1. This equipment can also be used as a placement plate; Edge grinding; Plate receiving assembly line,

    1.2 Plate collecting and releasing machines can be purchased as required;

    1.3 The plate collector and plate dispenser are independent operation panels;

    1.4 One time process can grind all sides to improve production efficiency

    1.5 It is unnecessary to stop the machine to adjust the size due to the size of the plate

    1.6 Select and purchase automatic board retracting and releasing machine, and load and unload materials with trolley, saving time and effort

    1.7 Anti scratching function of plate collecting machine

    1.8 Automatic correction of feeding

    1.9 Use polycrystalline diamond edge sharpening knife to ensure fine edge grinding quality

    2.0 Parameters can be set on human-machine interface with various plates

    Equipment Configuration/Specifications/Parameters/Performance Table:


    Equipment Specification Table

    Remarks

    1. Power specifications

    AC380V/50HZ/3PH+N (neutral line)+E (ground wire)

    32A circuit breaker control power supply, total power consumption: 3KW


    2. Air source specification

    0.6MPA  100NL/MIN



    3. Dust collection equipment

    Maximum static pressure: 500~900mmaq

    Air volume: 30~60M ³/ Min

    Diameter of dust collection pipe: outer diameter Φ 50mm pipe is connected to the installation position;



    4. Overall dimensions of the machine

    L6419*1500*1220mm


    5. Machine weight

    About 800KG


    B, Process Capability



    1. Grinding plate thickness

    0.6~2.4mm


    2. Panel size

    Max:760*760mm, & nbsp; Min:280*280mm;


    3. Rate of production

    About 8PCS/Min


    4. Working height

    850±30mm


    C, edging machine

    Double edge grinding


    1. Edge grinding angle

    90 ° angle


    2. Edging amount

    Average 1~1.5mm on each side (adjustable)



    D, edge grinding tool

    1. Diamond cutter specification: Ø 83 * 25.4 * R0.5 * 6Z

    2. Service life: tested with 500 * 500 * 1mm plate, more than 20000~30000 pieces

    3. Grinding times: about 4~6 times (under normal use)


    4. Tool change time

    1min/tablet


    5. Adjustment method of feed rate

    Mechanical screw adjustment


    6. Plate thickness adjustment method

    Mechanical screw adjustment


    7. Board sizing method

    No adjustment required (length * width)


    9. Edge grinding quality

    The amount of edge grinding is even, the plate edge is smooth, and there is no burr


    10. Positioning edge method

    The inclined roller locates the PCB edge


    11. Dust collection mode

    Streamlined dust collecting cover, connected to 2 "hose (about φ 50mm)